AS-3640

11.14 Additional display texts
Under certain circumstances, additional information texts may be shown in the main
display. In the table below you find descriptions for the different information texts.
Information in main display
Test
WaitEOT
NoData!
PapRUN
NoPaper
R&P Mode
R&P&V
R&A&P
CleanHds
Description
The printer is running test prints.
A pause command was sent to the printer. It will only
continue with the print job, when the Ok key is
pressed.
The data for a page was not sent completely to the
printer.
The printer is running a paper run test.
Data but no paper. E.g. the feeder is empty.
Only occurs in a specific, non-standard printer mode.
This text is shown when the Read and Print mode is
active. In this mode the printer receives the data for
each page, only after the data was read by an
external device (e.g. a camera or a barcode reader).
At typical application is the use of the printer behind
an inserter machine. This mode allows specific
settings for status feedbacks by the printer and
handling of no data events.
Only occurs in a specific, non-standard printer mode.
This text is shown when the Read and Print and
Verify mode is active. This mode works like the Read
and Print mode, plus each page must be verified as
“ok” after the printer, otherwise the page will be
flagged as faulty. A faulty page could for example be
diverted after the printer.
Only occurs in a specific, non-standard printer mode.
This text is shown when the Read and Acknowledge
and Print mode is active. This mode works like the
Read and Print mode, plus each page must be
acknowledged as “ok” right before the printer,
otherwise the page will be flagged as faulty. A faulty
page could for example be diverted after the printer.
Only occurs in a specific, non-standard printer mode.
This text is shown as answer, to a clean heads
request, sent over the serial port. This request can
only be used when one of the Read and X modes is
active.
User Manual Version 3.1 197