AS-3640
AS-3640
AS-3640
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Pos: 127 /Bedienungsanleitungen/Geräte spezifisch/Drucker/<strong>AS</strong>-Orbit/11.x_Ü2_Mounting two print units on one mounting bar_<strong>AS</strong>-Orbit/OrbitBase @ 2\mod_1266917840288_912.doc @ 12441 @ 2<br />
11.9 How to position the encoder wheel mounting<br />
The encoder wheel mounting of the Neopost <strong>AS</strong>-<strong>3640</strong> is pre-assembled. If the position of<br />
the encoder wheel mounting has to be shifted due to modifications or repairs, the default<br />
settings have to be restored.<br />
A B C D E<br />
Encoder wheel<br />
Print medium<br />
Figure 81: Position of the encoder wheel on the belt (schematical)<br />
A small spring load between encoder wheel and conveyor belt in the range between 1 N and<br />
2 N is suggested.<br />
The encoder wheel should be installed in such a way that it can roll<br />
unimpeded on the conveyor belt. The encoder wheel should be<br />
installed close to the first print unit.<br />
The print media must not collide with the encoder wheel. The encoder<br />
wheel can get damaged and the printouts may be faulty.<br />
The illustration of Figure 81 shows different scenarios for mounting the encoder wheel to<br />
the conveyor belt.<br />
• A: Recommended encoder wheel position.<br />
• B: Don’t position the encoder above the holes of the belt.<br />
• C: Don’t position the wheel in range of the product stream. The encoder wheel shall<br />
not roll over the edges of the products.<br />
• D: Be aware of not to mount the encoder wheel in a sloped position. The wheel has to<br />
be aligned parallel to the belt.<br />
• E: Don’t position the wheel at the turnaround edge of the belt.<br />
190 User Manual Version 3.1
Change language