AS-3640

Pos: 75.77 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_1804_RELAY2 OUTPUT_AS-3060A, 620, Orbit, OrbitB @ 0\mod_1254913755613_912.doc @ 4855 @
on print base
SET TIME[s]
on serial belt
SET TIME[s]
on 3rd party belt
SET TIME[s]
downstream from the printer.
on print base
Use this setting when the dryer is mounted on the
same Neopost Base conveyor as the print unit(s). The
dryer will be turned off when a stop of this conveyor is
detected by the printer. At SET TIME[s] you can set
the duration (in seconds) the dryer remains turned on
after the last pages exited the printer.
(0 – 60 sec. / Default: 5 seconds)
on serial belt
Use this setting when the dryer is mounted on a serial
connected Neopost conveyor. The dryer will be turned
off when a stop of this conveyor is detected by the
printer. At SET TIME[s] you can set the duration (in
seconds) the dryer remains turned on after the last
pages exited the printer.
(0 – 60 sec. / Default: 5 seconds)
on 3rd party belt
Use this setting when the dryer is mounted on a third
party conveyor belt which is controlled independently
from the printer. At SET TIME[s] you can set the
duration (in seconds) the dryer remains turned on
after the last pages exited the printer.
(0 – 60 sec. / Default: 5 seconds)
divert
DISTANCE
Using a dryer!
Review all settings carefully before using a dryer!
Never operate a dryer without supervision of an operator!
Control option for a diverter placed behind the printer
(inline). The distance between paper sensor and
device has to be entered (range 0 – 5,000 mm). The
width (duration) of the signal pulse is calculated from
the transport speed and the material size in transport
direction. Any device in-between the printer and the
diverter can influence the distance.
divert works for devices which are downstream from
the printer.
Trigger divert
The divert function must be
triggered from a PC application.
Default: feeder control
80 User Manual Version 3.1