AS-3640

Pos: 75.103 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü2/Ü2_2600_2601_PAPER SENSOR_AS-3060A/2060/Orbit/OrbitBase_ONLY @ 0\mod_1254832325313_912.doc @ 4357 @
TYPE OF BARCODE
You can choose between different predefined bar code systems. When activated, the
incoming ASCII character stream will automatically converted into bar code characters. (You
can print any bar code, if you use a modern Microsoft Windows computer).
zip, bpo4, kix, 2/5i, codabar, code 39, ean, code 128, code 93, AUS4state
(FORMAT CONTROL: 4state11, 4state45, 4state59, 4state62; CUSTOMER ENCODING: C
table, N table), canada, IMB, off,
Default: off
PAPER SENSOR
Here you can adjust the behaviour of the paper sensor.
Option
On
Off
Note
The paper sensor (also Top of Form (TOF) sensor)
detects the front edge and the rear edge of the
material. In this setting the paper sensor is active
over the complete length of the material. The paper
length is controlled in this setting, so paper jams or
double feeds will be detected.
When selecting Off you must choose between:
blank colourpaper
The paper sensor detects the front edge of the
material. Then the paper sensor is set to inactive until
5 mm before the anticipated rear edge of the
material. This allows to process materials that have
e.g. a colourful surface or a hole (die cut) in them.
The paper length is controlled in this setting, so paper
jams or double feeds will be detected.
To properly use this setting, the
correct material size must be
set in the printer. Either sent by
the PC software or measured
manually.
If the material separation and
transport is not setup correctly,
turning off the paper sensor can
cause misprints.
no pap.size check
The paper sensor only detects the front edge of the
material and is then inactive within the set paper
length. This allows to process materials of different
lengths. The paper length is not controlled in this
setting, so paper jams or double feeds will not be
detected!
User Manual Version 3.1 89