AS-3640
AS-3640
AS-3640
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Pos: 75.90 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Menü_Drucker_Hinweis_only with Neopost Feeder @ 2\mod_1267706650377_912.doc @ 12990 @<br />
Pos: 75.91 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_2204_BELT STOP END JOB @ 0\mod_1254912882657_912.doc @ 4827 @<br />
Pos: 75.92 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_2205_BELT STOP MIDDLE @ 0\mod_1254913755128_912.doc @ 4851 @ 8<br />
Pos: 75.93 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_2213_PAUSE CONFIG._FROM_4.8 @ 3\mod_1298293346574_912.doc @ 30499 @<br />
Pos: 75.94 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü2/Ü2_2300_LAYOUT @ 0\mod_1254831971240_912.doc @ 4345 @<br />
SEPARATION<br />
Here the paper separation can be adjusted. The gap between two sheets of paper can be<br />
varied in eleven different steps. It can be useful to increase this level, if paper jams occur<br />
many at a time (sometime when working with very slippery papers). This options works<br />
only with feeders which can be speed controlled by the print system.<br />
minim, level1, level2, ..., maxim<br />
Default: level2<br />
This options is only available when a Neopost FD-13/FD-15<br />
Feeder is connected to the print system.<br />
BELT STOP END JOB<br />
This feature is used to set for how long the transport belt of the printer should continue<br />
running after a print job was finished.<br />
off, default, 1minute, 2minutes, 3minutes, 4minutes, 5minutes<br />
Default: default<br />
BELT STOP MIDDLE<br />
This features is used to set for how long the belt continues to run in the event of a<br />
disturbance during the print job (e.g. no paper feed).<br />
off, default, 1minute, 2minutes, 3minutes, 4minutes, 5minutes<br />
Default: default<br />
PAUSE CONFIG.<br />
Use this feature to set the behaviour of the transport belt when a pause sequence was<br />
received by the printer. The pause sequence is used for e.g. post code or batch sorting.<br />
Option<br />
Stop Belt<br />
Run Belt<br />
Note<br />
The transport belt will stop when a pause sequence is<br />
received by the printer.<br />
The transport belt will continue to run when a pause<br />
sequence is received by the printer.<br />
Default: Stop Belt<br />
86 User Manual Version 3.1
Change language