AS-3640
AS-3640
AS-3640
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Pos: 126 /Bedienungsanleitungen/Geräte spezifisch/Drucker/<strong>AS</strong>-OrbitBase/11.1_Ü2_Print unit, Paper sensor, Encoder wheel positioning_<strong>AS</strong>-OrbitBase @ 2\mod_1265895981635_912.doc @ 11957 @ 222<br />
6. Starting the<br />
printer for the<br />
first time after<br />
the update<br />
• If you were updating from a flashware version < 4.7 then perform<br />
the steps below. If not continue with step “7. Checking the<br />
flashware version”.<br />
• Press and hold the Home key and turn on the printer. This<br />
will perform a default reset.<br />
• Keeping holding the Home key until the printer shows<br />
Printer Name<br />
Default Reset<br />
• Use the Setting Dump, printed at the beginning of this process,<br />
to set the previous mechanical alignment values.<br />
7. Checking<br />
the flashware<br />
version<br />
• Check the now installed flashware version in the printer menu:<br />
SERVICE > CONFIGURAT. INFO > Firmware:<br />
• Now the flashware update is completed.<br />
IMPORTANT!<br />
If an error message appears during the update process, just turn the<br />
printer off and on. Check if you are sending a compatible Flashware<br />
file. Try to resend the file.<br />
11.7 How to position the print unit guide bars<br />
The print unit guide bars of the Neopost <strong>AS</strong>-<strong>3640</strong> are pre-assembled and aligned to the<br />
conveyor belt surface. If the position of the print units has to be shifted due to modifications<br />
or repairs, the default settings have to be restored.<br />
• The guide bar has to be in the right angle to the transport direction.<br />
• The guide bar has to be parallel to the conveyor belt surface.<br />
• In the lowest position of the scaled adjustment wheel the printhead must not touch<br />
the conveyor belt. Between material surface and print unit should be a distance of 0.8<br />
mm / 0.03".<br />
• The recommended and pre-adjusted horizontal distance between the print units is<br />
164.9 mm / 6.49”. If the actual distance between the units should differ, use the<br />
option DIST. U1-U2 / DIST. U2-U3 / DIST. U3-U4, on page 60 to adjust the set value.<br />
The maximum value is 200 mm / 7,87”.<br />
Horizontal distance between the print units<br />
Good print results may only be achieved if the distances are<br />
measured exactly and set correctly in the printer options.<br />
186 User Manual Version 3.1
Change language