DE2-115: User Manual

More documents

Recommendations

Info

Figure 6-23 Block diagram of the Music Synthesizer design • Demonstration Setup, File Locations, and Instructions Project directory: DE2_115_Synthesizer Bit stream used: DE2_115_Synthesizer.sof or DE2-115_Synthesizer.pof Connect a PS/2 Keyboard to the DE2-115 board. Connect the VGA output of the DE2-115 board to a VGA monitor (both LCD and CRT type of monitors should work) Connect the lineout of the DE2-115 board to a speaker. Load the bit stream into FPGA by executing DE2_115_Synthesizer\demo_batch\DE2_115_Synthesizer.bat file Make sure all the switches (SW[9:0]) are set to 0 (Down Position) Press KEY1 on the DE2-115 board to start the music demo Press KEY0 on the DE2-115 board to reset the circuit Note: If the HSMC loopback adapter is mounted, the I2C_SCL will be directly routed back to I2C_SDA. Because audio chip, TV decoder chip and HSMC share one I2C bus, therefore audio and video chip won’t function correctly. 101
Table 6-5 and Table 6-6 illustrate the usage of the slide switches, push-button switches (KEYs), PS/2 Keyboard. Slide Switches and Push-buttons switches Table 6-5 Usage of the slide switches and push-buttons switches (KEYs) Signal Name KEY[0] KEY[1] SW[0] SW[9] SW[1] SW[2] Description Reset Circuit Repeat the Demo Music OFF: BRASS, ON: STRING OFF: DEMO, ON: PS/2 KEYBOARD Channel-1 ON / OFF Channel-2 ON / OFF PS/2 Keyboard Signal Name Q -#4 A -5 W -#5 S -6 E -#6 D -7 F 1 T #1 G 2 Y #2 H 3 J 4 I #4 K 5 O #5 L 6 P #6 : 7 “ +1 Table 6-6 Description Usage of the PS/2 Keyboard Keys 102
Page 2 and 3:
CONTENTS Chapter 1 DE2-115 Package
Page 4 and 5:
6.9 IR Receiver Demonstration .....
Page 6 and 7:
Bag of six rubber (silicon) covers
Page 8 and 9:
Chapter 2 Introduction of the Alter
Page 10 and 11:
One 40-pin Expansion Header with di
Page 12 and 13:
40-pin expansion port o Configurabl
Page 14 and 15:
You can also connect a microphone t
Page 16 and 17:
5. The DE2_115_ControlPanel.sof bit
Page 18 and 19:
Figure 3-3 Controlling LEDs Choosin
Page 20 and 21:
Figure 3-6 Monitoring switches and
Page 22 and 23:
The Sequential Read function is use
Page 24 and 25:
3.7 SD Card The function is designe
Page 26 and 27:
1. Choosing the VGA tab leads to th
Page 28 and 29:
Figure 3-14 Testing the IR receiver
Page 30 and 31:
Chapter 4 Using the DE2-115 Board T
Page 32 and 33:
• Configuring the FPGA in JTAG Mo
Page 34 and 35:
Figure 4-6 Connections between the
Page 36 and 37:
Table 4-1 Pin Assignments for Slide
Page 38 and 39:
HEX0[5] PIN_J22 Seven Segment Digit
Page 40 and 41:
4.6 Using the LCD Module The LCD mo
Page 42 and 43:
Figure 4-13 HSMC VCCIO supply volta
Page 44 and 45:
HSMC_RX_D_N[1] PIN_C27 HSMC_RX_D_N[
Page 46 and 47:
HSMC_TX_D_N[14] PIN_U28 HSMC_TX_D_N
Page 48 and 49:
The voltage level of the I/O pins o
Page 50 and 51:
Figure 4-19 Using Emulated LVDS on
Page 52 and 53: 4.10 Using VGA The DE2-115 board in
Page 54 and 55: Table 4-16 Pin Assignments for ADV7
Page 56 and 57: Figure 4-24 Connections between FPG
Page 58 and 59: You will need to perform a hardware
Page 60 and 61: ENET1_TX_CLK PIN_C22 MII transmit c
Page 62 and 63: 4.17 Using the USB Interface The DE
Page 64 and 65: Table 4-26 IR Pin Assignments Signa
Page 66 and 67: • EEPROM The board has 32Kb EEPRO
Page 68 and 69: SRAM_DQ[7] PIN_AF7 SRAM Data[7] 3.3
Page 70 and 71: FL_ADDR[15] PIN_Y10 FLASH Address[1
Page 72 and 73: The top-level design file contains
Page 74 and 75: • System Configuration Under Syst
Page 76 and 77: Figure 5-6 HSMC Expansion Group The
Page 78 and 79: Chapter 6 Examples of Advanced Demo
Page 80 and 81: Finally, the YcrCb_to_RGB block con
Page 82 and 83: mouse connected to DE2-115 board. W
Page 84 and 85: sends a different USB packet to the
Page 86 and 87: Figure 6-7 Block diagram of the Kar
Page 88 and 89: Figure 6-9 Block Diagram of the SD
Page 90 and 91: Figure 6-11 Insert SD Card for the
Page 92 and 93: Main WAVE Lib System Call SEG7 I2C
Page 94 and 95: Figure 6-15 The setup for the SD mu
Page 96 and 97: Figure 6-16 Waveforms on two lines
Page 98 and 99: Figure 6-18 Remote controller Table
Page 100 and 101: We can apply the IR receiver to man
Page 104 and 105: Figure 6-24 The Setup of the Music
Page 106 and 107: • Demonstration Setup, File Locat
Page 108 and 109: Figure 6-27 MII interface MAC Confi
Page 110 and 111: Figure 6-29 MAC Options Configurati
Page 112 and 113: Figure 6-32 PHY connected to the MA
Page 114 and 115: Ethernet 1 respectively. Table 6-9
Page 116: Chapter 7 Appendix 7.1 Revision His
show all

DE2-115: User Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?