- Page 2 and 3:
CONTENTS Chapter 1 DE2-115 Package
- Page 4 and 5:
6.9 IR Receiver Demonstration .....
- Page 6 and 7:
Bag of six rubber (silicon) covers
- Page 8 and 9:
Chapter 2 Introduction of the Alter
- Page 10 and 11:
One 40-pin Expansion Header with di
- Page 12 and 13:
40-pin expansion port o Configurabl
- Page 14 and 15:
You can also connect a microphone t
- Page 16 and 17:
5. The DE2_115_ControlPanel.sof bit
- Page 18 and 19:
Figure 3-3 Controlling LEDs Choosin
- Page 20 and 21:
Figure 3-6 Monitoring switches and
- Page 22 and 23:
The Sequential Read function is use
- Page 24 and 25:
3.7 SD Card The function is designe
- Page 26 and 27:
1. Choosing the VGA tab leads to th
- Page 28 and 29:
Figure 3-14 Testing the IR receiver
- Page 30 and 31:
Chapter 4 Using the DE2-115 Board T
- Page 32 and 33:
• Configuring the FPGA in JTAG Mo
- Page 34 and 35:
Figure 4-6 Connections between the
- Page 36 and 37:
Table 4-1 Pin Assignments for Slide
- Page 38 and 39:
HEX0[5] PIN_J22 Seven Segment Digit
- Page 40 and 41:
4.6 Using the LCD Module The LCD mo
- Page 42 and 43:
Figure 4-13 HSMC VCCIO supply volta
- Page 44 and 45:
HSMC_RX_D_N[1] PIN_C27 HSMC_RX_D_N[
- Page 46 and 47:
HSMC_TX_D_N[14] PIN_U28 HSMC_TX_D_N
- Page 48 and 49:
The voltage level of the I/O pins o
- Page 50 and 51:
Figure 4-19 Using Emulated LVDS on
- Page 52 and 53:
4.10 Using VGA The DE2-115 board in
- Page 54 and 55:
Table 4-16 Pin Assignments for ADV7
- Page 56 and 57:
Figure 4-24 Connections between FPG
- Page 58 and 59: You will need to perform a hardware
- Page 60 and 61: ENET1_TX_CLK PIN_C22 MII transmit c
- Page 62 and 63: 4.17 Using the USB Interface The DE
- Page 64 and 65: Table 4-26 IR Pin Assignments Signa
- Page 66 and 67: • EEPROM The board has 32Kb EEPRO
- Page 68 and 69: SRAM_DQ[7] PIN_AF7 SRAM Data[7] 3.3
- Page 70 and 71: FL_ADDR[15] PIN_Y10 FLASH Address[1
- Page 72 and 73: The top-level design file contains
- Page 74 and 75: • System Configuration Under Syst
- Page 76 and 77: Figure 5-6 HSMC Expansion Group The
- Page 78 and 79: Chapter 6 Examples of Advanced Demo
- Page 80 and 81: Finally, the YcrCb_to_RGB block con
- Page 82 and 83: mouse connected to DE2-115 board. W
- Page 84 and 85: sends a different USB packet to the
- Page 86 and 87: Figure 6-7 Block diagram of the Kar
- Page 88 and 89: Figure 6-9 Block Diagram of the SD
- Page 90 and 91: Figure 6-11 Insert SD Card for the
- Page 92 and 93: Main WAVE Lib System Call SEG7 I2C
- Page 94 and 95: Figure 6-15 The setup for the SD mu
- Page 96 and 97: Figure 6-16 Waveforms on two lines
- Page 98 and 99: Figure 6-18 Remote controller Table
- Page 100 and 101: We can apply the IR receiver to man
- Page 102 and 103: Figure 6-23 Block diagram of the Mu
- Page 104 and 105: Figure 6-24 The Setup of the Music
- Page 106 and 107: • Demonstration Setup, File Locat
- Page 110 and 111: Figure 6-29 MAC Options Configurati
- Page 112 and 113: Figure 6-32 PHY connected to the MA
- Page 114 and 115: Ethernet 1 respectively. Table 6-9
- Page 116: Chapter 7 Appendix 7.1 Revision His