DE2-115: User Manual

More documents

Recommendations

Info

Table 4-26 IR Pin Assignments Signal Name FPGA Pin No. Description I/O Standard IRDA_RXD PIN_Y15 IR Receiver 3.3V 4.19 Using SRAM/SDRAM/FLASH/EEPROM/SD Card • SRAM The <strong>DE2</strong>-<strong>115</strong> board has 2MB SRAM memory with 16-bit data width. Being featured with a maximum performance frequency of about 125MHz under the condition of standard 3.3V single power supply makes it suitable of dealing with high-speed media processing applications that need ultra data throughput. The related schematic is shown in Figure 4-33. Figure 4-33 Connections between FPGA and SRAM • SDRAM The board features 128MB of SDRAM, implemented using two 64MB SDRAM devices. Each device consists of separate 16-bit data lines connected to the FPGA, and shared control and address lines. These chips use the 3.3V LVCMOS signaling standard. Connections between FPGA and SDRAM are shown in Figure 4-34. 63
Figure 4-34 Connections between FPGA and SDRAM • FLASH The board is assembled with 8MB of flash memory using an 8-bit data bus. The device uses 3.3V CMOS signaling standard. Because of its non-volatile property, it is usually used for storing software binaries, images, sounds or other media. Connections between FPGA and Flash are shown in Figure 4-35. Figure 4-35 Connections between FPGA and Flash 64
Page 2 and 3:
CONTENTS Chapter 1 DE2-115 Package
Page 4 and 5:
6.9 IR Receiver Demonstration .....
Page 6 and 7:
Bag of six rubber (silicon) covers
Page 8 and 9:
Chapter 2 Introduction of the Alter
Page 10 and 11:
One 40-pin Expansion Header with di
Page 12 and 13:
40-pin expansion port o Configurabl
Page 14 and 15: You can also connect a microphone t
Page 16 and 17: 5. The DE2_115_ControlPanel.sof bit
Page 18 and 19: Figure 3-3 Controlling LEDs Choosin
Page 20 and 21: Figure 3-6 Monitoring switches and
Page 22 and 23: The Sequential Read function is use
Page 24 and 25: 3.7 SD Card The function is designe
Page 26 and 27: 1. Choosing the VGA tab leads to th
Page 28 and 29: Figure 3-14 Testing the IR receiver
Page 30 and 31: Chapter 4 Using the DE2-115 Board T
Page 32 and 33: • Configuring the FPGA in JTAG Mo
Page 34 and 35: Figure 4-6 Connections between the
Page 36 and 37: Table 4-1 Pin Assignments for Slide
Page 38 and 39: HEX0[5] PIN_J22 Seven Segment Digit
Page 40 and 41: 4.6 Using the LCD Module The LCD mo
Page 42 and 43: Figure 4-13 HSMC VCCIO supply volta
Page 44 and 45: HSMC_RX_D_N[1] PIN_C27 HSMC_RX_D_N[
Page 46 and 47: HSMC_TX_D_N[14] PIN_U28 HSMC_TX_D_N
Page 48 and 49: The voltage level of the I/O pins o
Page 50 and 51: Figure 4-19 Using Emulated LVDS on
Page 52 and 53: 4.10 Using VGA The DE2-115 board in
Page 54 and 55: Table 4-16 Pin Assignments for ADV7
Page 56 and 57: Figure 4-24 Connections between FPG
Page 58 and 59: You will need to perform a hardware
Page 60 and 61: ENET1_TX_CLK PIN_C22 MII transmit c
Page 62 and 63: 4.17 Using the USB Interface The DE
Page 66 and 67: • EEPROM The board has 32Kb EEPRO
Page 68 and 69: SRAM_DQ[7] PIN_AF7 SRAM Data[7] 3.3
Page 70 and 71: FL_ADDR[15] PIN_Y10 FLASH Address[1
Page 72 and 73: The top-level design file contains
Page 74 and 75: • System Configuration Under Syst
Page 76 and 77: Figure 5-6 HSMC Expansion Group The
Page 78 and 79: Chapter 6 Examples of Advanced Demo
Page 80 and 81: Finally, the YcrCb_to_RGB block con
Page 82 and 83: mouse connected to DE2-115 board. W
Page 84 and 85: sends a different USB packet to the
Page 86 and 87: Figure 6-7 Block diagram of the Kar
Page 88 and 89: Figure 6-9 Block Diagram of the SD
Page 90 and 91: Figure 6-11 Insert SD Card for the
Page 92 and 93: Main WAVE Lib System Call SEG7 I2C
Page 94 and 95: Figure 6-15 The setup for the SD mu
Page 96 and 97: Figure 6-16 Waveforms on two lines
Page 98 and 99: Figure 6-18 Remote controller Table
Page 100 and 101: We can apply the IR receiver to man
Page 102 and 103: Figure 6-23 Block diagram of the Mu
Page 104 and 105: Figure 6-24 The Setup of the Music
Page 106 and 107: • Demonstration Setup, File Locat
Page 108 and 109: Figure 6-27 MII interface MAC Confi
Page 110 and 111: Figure 6-29 MAC Options Configurati
Page 112 and 113: Figure 6-32 PHY connected to the MA
Page 114 and 115:
Ethernet 1 respectively. Table 6-9
Page 116:
Chapter 7 Appendix 7.1 Revision His
show all

DE2-115: User Manual

Create successful ePaper yourself

Delete template?

Save as template?