Silver Series Installation and Operation Manual, Rev B ... - Watlow

136 Silver Series Programming Manual4. Click Settings... Click the Use shape checkbox, and then click the Shape Library… button.5. Select a shape for your fast selection button and click OK.6. Click OK. The Fast Selection window can only call full screen windows, not popup windows. Therefore, you cannot useFunction Key Objects configured to Display popup window in Fast Selection windows.System Message WindowsEasyBuilder has four Windows designated as System Message windows. Window #5 is designated as the PLCResponse Window that pops up automatically when the HMI loses communications with the PLC.Window #6 is designated as the HMI Response window, which will pop up automatically with the HMI losescommunications with another HMI that is remotely connected.Window #7 is designated as the Password Restriction Window, which will pop up when access is attempted on aprotected object without the proper password. The Display warning message if access denied checkbox must beenabled in the Security tab > User restriction section of the object.These windows have been pre-configured with automated messages and a function key to close the window, so nochanges are necessary, though you may customize them for your own application if desired.Window #8 is designated as the Insufficient Memory Window, which will pop up when the available memory in theHMI, USB Flash drive, or SD card is running low. This window must be created by the programmer, and it can beconfigured to indicate which device has triggered the message. The following Reserved Local Bits indicate insufficientmemory conditions:LB9035LB9036LB9037LB9038HMI free space insufficient alarm (when ON)SD Card free space insufficient alarm (when ON)USB 1 free space insufficient alarm (when ON)USB 2 free space insufficient alarm (when ON)0600-0069-0000 Rev. B