Silver Series Installation and Operation Manual, Rev B ... - Watlow

156 Silver Series Programming Manual11. In the Value section, select the Zero and Span values. These are the PLC register values that represent thezero and full-scale deflection of the meter’s arm.12. In the Range limits section, click the enable check box to enable the limits. Select the colors for low, mid andhigh. Select the width, in pixels, of the color band. The values from zero to low limit will be on the 'low' colorband; values from low limit to high limit will be on the 'mid' color band; and values greater than high limitwill be on the 'high' color band.13. Select the Low limit and High limit. These are the values used for the range limit color bands. Click theDynamic limits check box to allow PLC registers to determine the low and high limits. The low limit is thespecified register, and the high limit is the next consecutive register.14. The Scale label section allows you to enable labeling on the “main scale tick marks” inside the meter. Youcan select the font, color, size, and number of digits to the right of decimal point.15. If you'd like a background shape to appear with your meter, click the Shape tab and select a shape.16. Click OK. The meter appears on the work area of EasyBuilder. Click to drag and place your meter on yourwork area. If you need to reconfigure any of the properties, deselect the meter and then double click on itand the properties dialog box will reappear.0600-0069-0000 Rev. B