Silver Series Installation and Operation Manual, Rev B ... - Watlow

Bar Graphs, Meters, and Trends 1555. In the Degree section, you can select the range of your meter, where the range is 0 to 360. The Start degree0 is at 12:00. Below are four examples of start and end degrees for different meters: Note that meters can have any start and end degree between 0 and 360.6. The Background section allows you to select background options for the meter. The following illustrationsshow how your meter will appear with different options checked:7. The Tick marks section allows you to configure the length, scale and sub-scale of the tick marks.8. In the Pointer section, select arm style, color, length, and width.9. The Pin point section allows you to adjust the style and size of the pinpoint. See the illustration above to seethe pinpoint (the center of the meter).10. Select the Limits tab. In this section, you can configure a scale that goes on the face of the meter that showsby a color indication when high and low limits have been exceeded. If you look at the above examples, youwill see this is represented on the face of the meter as a red, yellow and green strip.0600-0069-0000 Rev. B