Silver Series Installation and Operation Manual, Rev B ... - Watlow

76 Silver Series Programming Manual2. Click and hold down the left mouse button at the upper left corner of the graphics objects you wish tohighlight.3. Drag the mouse cursor to the lower right corner of the highlighted objects. Notice that a rectangle is formedas you do this.4. Release the mouse button. The rectangle outline changes to small clear square blocks around the perimeterof the objects selected. Now both objects are selected. If you do not completely enclose any graphics objects you wish to highlight, then they will not be selected.5. Alternatively, you may select objects by holding down the CTRL key while selecting each object until allobjects are selected.6. When several graphics objects are selected, they can easily be moved, deleted or copied together.To select next object1. This option can be used to easily select an object that is underneath another object on the screen. To use thisoption, you must first select the overlapping object.2. On the Edit Menu, click Select Next Object or click on the Select Next Object icon on the Standard Toolbar.You can also right-click on the top-most object on the screen. This will display a menu with a list of theoverlapping objects on the bottom. Then check the object that you wish to access.3. Once the object you are trying to access is selected, you can proceed to modify its attributes or delete it.To select all objects1. On the Edit Menu, click Select All Objects.2. Small, clear, square blocks appear around the perimeter of all the objects on the window.3. You can now easily move, delete or copy the entire window screen to a new window.Using the Undo and Redo commands1. The Undo command is used to cancel the last command or action that you made.2. Press the DELETE key on your keyboard to delete the text box.3. From the Edit menu, click Undo or click the Undo icon from the Standard Toolbar. You can also pressCTRL+Z. The deleted text box reappears.4. The Redo command is used to cancel the Undo command.Using the Cut , Copy , and Paste commands1. These commands are all selected from the Edit menu.2. Select the graphics object or objects you wish to cut or copy.3. Click Cut to copy and remove the graphics object(s) from the work area or click Copy to copy the graphicsobject(s).0600-0069-0000 Rev. B