Silver Series Installation and Operation Manual, Rev B ... - Watlow

Creating a Sample Project 492. Connect the HMI to your computer using the USB configuration cable (PN 7431-0115).3. Select Tools > Download from EasyBuilder’s menu (or click the Download icon).4. Make sure that the USB, Firmware, and Reboot HMI After Download boxes are checked.5. Click the Download button. If the HMI is properly connected to the PC, the status box on the downloaddialog will update with messages indicating the progress of the transfer. The HMI itself will also displaymessages reflecting its status.6. When the download is complete, the HMI will restart and begin running your project. Click the Exit button onthe Download dialog.Note: When connecting two powered devices, a difference in potential can exist between the ground referenceon each device. If there is a large difference in ground potential (voltage), making a connection via a USB cablecan complete a ground loop that may damage the HMI and PC. The connectors on the Maple Systems USBConfiguration Cable (P/N 7431-0115) are electrically isolated to prevent a potentially damaging ground loop, andwe recommend using this cable to connect the HMI to the PC. Maple Systems cannot be held responsible for anydamage to the HMI, PLC, or PC due to improper wiring. Please refer to page 5 of the HMI5000 Series Installation Guide forproper wiring instructions.CONGRATULATIONS. You have completed your first EZware-5000 project. Select File > Exit to close EasyBuilder.0600-0069-0000 Rev. B