Silver Series Installation and Operation Manual, Rev B ... - Watlow

Creating a Sample Project 454. Click OK and place the Set Bit Object on the window. It will appear as a square frame. Click on the screen todeselect it, then double-click on it to reopen the properties (or right-click on it and select Attribute). Click theProfile tab and set the Width and Height to 65 (pixels). Click OK to accept the new Profile settings.5. Move the Set Bit Object over the Arrow Up button.6. Copy and paste the Set Bit Object and place the second one over the Arrow Down button. When the Up orDown buttons are pressed, the pump and pipe will change states to indicate that they are on.Finishing UpThere are still a few more steps to finish your first project. In this section, you will:• save the project onto your computer hard drive• compile the project into a format that can be understood by the HMI• run the offline simulator to test the project• download the project to the HMI• verify that the HMI operates as expected• exit the EZware-5000 softwareSaving your first project1. From the File menu, click Save As. The Save As dialog box appears.0600-0069-0000 Rev. B