Silver Series Installation and Operation Manual, Rev B ... - Watlow

150 Silver Series Programming Manual5. Click OK and place the Direct Window Object anywhere on the window.6. From the Window menu, select Open Window. Select Window 50 Keypad Integer and click the Settingsbutton to open the Window Settings Properties. Note the Width and Height of the window (e.g., 160x186).Click OK and then Exit.7. Double-click on the Direct Window Object to open the Properties window. Click the Profile tab and enter theWidth and Height of Window 50 into the Width and Height fields of the Direct Window. This will cause theDirect Window to be correctly sized for the keypad. Click OK to close the Properties window.8. From the Objects menu, select Button > Set Bit. The New Set Bit Object Properties window opens. Select aWrite Address of LB10 and select Set Style: Set On.9. Click on the Shape tab and uncheck Use Shape.10. Click OK and place the Set Bit Object over the Numeric Input Object. Resize the Set Bit Object by clicking anddragging its corners so it is the same size as the Numeric Input Object (or set the Width and Height in theProfile tab of the Set Bit Object to the same settings as the Numeric Input Object). This will trigger theKeypad to pop up in the Direct Window when the Numeric Input is pressed or clicked.11. Copy the Set Bit Object and open Window 50. Paste the Set Bit Object into Window 50. Double-click on it toopen the Properties. Change the Set Style to Set Off. Click OK and place the Set Bit Object over the Enter keyon the keypad. Resize the Set Bit Object so it is the same size as the Enter key. Copy the Set Bit Object andplace it over the Esc key. This will close the Keypad when the Enter or Esc keys are pressed.To create a fixed keypad on a window instead of using a popup keypad or Direct Window:1. In the above sample project, create a new Numeric Input Object and deselect Use popup keypad on theData Entry tab. Click OK to close the Properties window.2. Copy your custom keypad into the window, or open Window 50 and copy the keypad over to Window 10.3. You must click or touch the Numeric Input Object first to activate it, enter a number using the keypad, thenpress Enter on the keypad to write the value to the register.0600-0069-0000 Rev. B