hager TX216 KNX/EIB DALI-Gateway - UTU
hager TX216 KNX/EIB DALI-Gateway - UTU
hager TX216 KNX/EIB DALI-Gateway - UTU
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>hager</strong>"<strong>DALI</strong> <strong>Gateway</strong> C00Cx2" softwareParametersResponse to bus voltagereturnThe <strong>Gateway</strong> permits to separately set thebrightness value for each <strong>DALI</strong> group afterbus or mains voltage return separately.Switch-offBrightness valueBrightness value as prior tobus voltage failureNo changeStart Staircase timer functionThe group will be switched off.The group will be adjusted to thebrightness value specified in the drop-downmenu next to the parameter. Theadjustable value is restricted by theparameterized minimum and maximumbrightness.After bus/ mains voltage return, thebrightness value that was internally storedlast prior to the bus/ mains voltage failurewill be tracked.Following a bus/ mains voltage failure, the<strong>DALI</strong> devices of a group will show noresponse and keep the current brightnessvalue or remain switched off.Independent of the “Switching” object, theStaircase timer function will be activatedafter bus/ mains voltage return. Make surethat the Staircase timer function has beenenabled. In case the Staircase timerfunction has not been enabled, this settingwill produce no reaction after the return ofbus/ mains voltage.• Setting “Brightness value as prior to busvoltage failure”: When programming theapplication or the parameters with theETS, the internally stored switching statewill be reset to “Off – 0".• The parameterized response will alwaysbe executed after bus/ mains voltagereturn. It must be pointed out that after abus/ mains voltage return a forcedcontrolposition might also be activatedwhich, if applicable, can affect thebrightness status of the group.Type of additionalfunctionNo additional functionDisable functionForced-control positionfunctionThis parameter can be used to define andto enable the additional function. Thedisable function can only be parameterizedas an alternative to the forced-controlposition function.Seite 113 von 130