hager TX216 KNX/EIB DALI-Gateway - UTU

hager"DALI Gateway C00Cx2" softwareParametersDimmingTime for relative dimming(0...100%)00:00:01 … 05:59:59[hh:mm:ss]5 sThis parameter will set the relative timeincrements (4-bit dimming). The timeentered defines the maximum duration forthe dimming across the entire brightnessrange from 0 % to 100 % brightness.Dimming response to abrightness valueDimJump toThis parameter determines whether abrightness value received via the bus(absolute dimming) will be instantly jumpedto or whether light intensity will dim to thebrightness.Time for absolutedimming (0...100%)00:00:01 … 23:59:59[hh:mm:ss]5 sThis parameter will set the time for theincrements increments (1-byte dimming).The time entered defines the maximumduration for the dimming across the entirebrightness range from 0 % to 100 %brightness.• This parameter becomes visible onlywhen set to: “Dimming response to abrightness value” = “Dim”.Automatic shutoff whenfalling below a specifiedbrightness ?YesNoThe automatic shutoff function for a groupcan be activated. If activated, the DALIdevices of the group will shut off completelyas soon as a parameterized brightness hasbeen reached or under-run at the end of adimming operation and, if applicable, afterthe delay time has lapsed.Shutoff when brightnessvalue smaller0.1 % … 100 %; 5 % This parameter determines the brightnessto be reached or under-run at the end of adimming operation that will cause the groupto be switched off, if applicable, after thedelay time has lapsed.• The adjustable value is restricted by theparameterized minimum and maximumbrightness. The standard setting will alsoadapt accordingly.• If the shutoff brightness has been underrunby a disable or forced-controlposition function or a staircase prewarningfunction, the shutoff function willnot be executed.• This parameter becomes visible only ifthe shutoff function has been enabled.Seite 122 von 130