hager TX216 KNX/EIB DALI-Gateway - UTU

hagerFitting, electrical connection and operationDALI device replacementAfter the start of the automatic device replacement, the DALI Gateway can check the DALI system forthe integrity of the DALI devices that have been previously put into operation. If, for instance, theinstaller has replaced a defect DALI electronic ballast device with a new one, the DALI Gateway is ableto program the new electronic ballast device with the project data of the failed electronic ballast device.Thus, it is possible to replace a failed DALI device by a simple operation on the device without havingto set parameters with the ETS.The DALI Gateway has been programmed at least once via the ETS.The automatic device replacement must be activated in the ETS.Bus and mains voltage (on all DALI devices) must be switched on.The DALI system must have already been put into operation via the ETS plug-in.Only one DALI device may have failed and may be replaced.The device must be in bus mode (no active manual control)• Press the and ALL OFF keys simultaneously for at least 10 s.The automatic device replacement will be activated. The time required for this operation depends onthe number of DALI devices available in the system. The 7-segment display indicates " " (Learn)during the device replacement. If the replacement has been successful, the display will extinguish.• All other functions of the DALI Gateway are paused during the device replacement. The Gatewaytracks all bus states received during the device replacement and regularly analysizes the valuestracked last (switching, dimming, brightness value, scenes, central function, forced-control position,disable function) at the end of the automatic device replacement. The device replacement willinterrupt any active forced-control position or disable function which will be activated again at the endof the replacement, if, in the meantime, the functions have not been deactivated via the bus. Thebehaviour as at the beginning of these functions will not be executed again.• Make sure that only one DALI device is being replaced in the way described. In case severalelectronic ballast devices have failed (possibly not connected to mains voltage) and been replaced,the electronic ballast devices cannot be positively identified and automatically be configured. In thiscase, a new DALI commissioning via the ETS plug-in is required.• If an error has occurred during the device replacement, the 7-segment display will indicate " "(Error) for 3 s. The procedure has to be carried out again by following the requirements and detailsas mentioned above.This signalling will take place even if the automatic device replacement has been activated without aprior DALI device replacement.Seite 17 von 130