hager TX216 KNX/EIB DALI-Gateway - UTU

More documents

Recommendations

Info

hager"DALI Gateway C00Cx2" softwareParametersResponse at the end ofthe disable functionSwitch-offBlinkingBrightness valueNo changeThe behaviour of the DALI group at the endof the disable function can beparameterized.At the end of the disable the group willswitched off and re-enabled.After the end of the disable, the DALIdevices of the group will be re-enabled forthe bus mode blinking on and off.Generally, the blinking time isparameterized for all groups on the"General" parameter card. During blinking,the logic switching state is "ON - 1". Thebrightness reported back is the switch-onbrightness. A Soft-ON/OFF function will beignored during the blinking. The blinkingstatus will remain active until another buscommand is received or until the manualcontrol will provide a different status.At the end of the disable, the group will beadjusted to the brightness value specifiedin the drop-down menu next to theparameter. The adjustable value isrestricted by the parameterized minimumand maximum brightness.At the end of the disable the DALI devicesof a group will not react and keep thecurrent brightness value or remainswitched off. The bus mode of the groupwill be re-enabled afterwards.• This parameter becomes visible only ifthe disable function is enabled.Seite 116 von 130
hager"DALI Gateway C00Cx2" softwareParametersResponse at the end ofthe disable function(continued)Memory value (brightnessprior to the last shutoff)Tracked brightness valueAt the end of the disable, the value will beadjusted to the brightness value that wasactive and internally stored prior to the lastswitch-off (via the “Switching” or “Switchingcentral function” object). This memoryvalue is non-permanently stored so that thevalue is pre-defined to the maximumbrightness after the return of bus voltage orafter programming with the ETS. The busmode of the group will be re-enabledafterwards.Time functions will be included.At the end of a disable, the status receivedor set prior to the executed disable functionwill be resumed with the applicablebrightness value. If applicable, active timefunctions will also be considered.• This parameter becomes visible only ifthe disable function is enabled.Seite 117 von 130
Page 3 and 4:
hagerProduct definition1 Product de
Page 5:
hagerFitting, electrical connection
Page 8 and 9:
Page 10 and 11:
Page 12 and 13:
Page 14 and 15:
Page 16 and 17:
Page 18 and 19:
hagerTechnical data3 Technical data
Page 20 and 21:
hagerSoftware specifications4 Softw
Page 22 and 23:
hager"DALI Gateway C00Cx2" software
Page 24 and 25:
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Page 38 and 39:
Page 40 and 41:
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
Page 58 and 59:
Page 60 and 61:
Page 62 and 63:
Page 64 and 65:
Page 66 and 67: hager"DALI Gateway C00Cx2" software
Page 130: hager"DALI Gateway C00Cx2" software
show all

hager TX216 KNX/EIB DALI-Gateway - UTU

Create successful ePaper yourself

Delete template?

Save as template?