hager TX216 KNX/EIB DALI-Gateway - UTU

hager"DALI Gateway C00Cx2" softwareParametersBrightness for forcedcontrolposition active,ONIf the forced-control position is active and aforced switching is “ON”, the parameter willdetermine the behaviour of the Group’sDALI devices.Brightness valueNo changeMemory value (brightnessprior to the last shutoff)The group will be adjusted to thebrightness value specified in the drop-downmenu next to the parameter. Theadjustable value is restricted by theparameterized minimum and maximumbrightness.The DALI devices of a group will not reactand keep the current brightness value orremain switched off.The value will be adjusted to the brightnessvalue that was active and internally storedprior to the last switch-off (via the“Switching” or “Switching central function”object). This memory value is permanentlystored so that the value is pre-defined tothe maximum brightness after the return ofbus or mains voltage or after programmingwith the ETS.• This parameter becomes visible only ifthe forced-control position function hasbeen enabled.Response at the end ofthe forced-controlposition functionThe response of the DALI group at the endof the forced-control position can beparameterized.No changeTracked brightness valueAt the end of the forced-control position,the DALI devices of a group will not reactand keep the current brightness value orremain switched off. The bus mode of thegroup will be re-enabled afterwards.At the end of a forced control, the statusreceived or set prior to the executedforced-control position function will beresumed with the applicable brightnessvalue. If applicable, active time functionswill also be considered. The bus mode ofthe group will be re-enabled afterwards.• This parameter becomes visible only ifthe forced-control position function hasbeen enabled.Seite 119 von 130