hager TX216 KNX/EIB DALI-Gateway - UTU

hagerFitting, electrical connection and operationPrioritiesThe DALI Gateway distinguishes between different functions that can affect a DALI group. In order toprevent conflicting output states, each available function has been assigned a certain priority. Thefunction with the higher priority overrides the one with the lower priority.– 1 st Priority: Manual control mode (highest priority)– 2 nd Priority: Forced-control position or disable function– 3 rd Priority: Direct bus mode (“Switching” & “Dimming” & “Brightness value” objects, scenes, centrafunction)Switching on the temporary manual control for the broadcast functionThe manual control for the broadcast function can be utilized while the DALI Gateway is in theunprogrammed state. As in this case no group configurations have been stored due to a missing ETSprogramming, the DALI Gateway will collectively control the connected DALI devices in manual controlper broadcast command.The DALI Gateway has not yet been programmed via the ETS.• Press the key briefly (< 1 s)." " is shown on the 7-segment display.• After 5 s without key-press, the Gateway will deactivate the manual control for the broadcast.• The Gateway is delivered with the broadcast mode activated. After programming via the ETS, it isalso possible to reactivate the broadcast mode any time by unloading the application program via theETS.Switching on the temporary manual control for broadcastThe DALI Gateway has not yet been programmed via the ETS.Temporary manual control mode for the broadcast has been activated.• No key-press for 5 s- or -• Press key twice.- or -• Switch off mains voltage supply.Temporary manual control mode for broadcast has now been terminated. The 7-segment display willextinguish.• When shutting off the temporary manual control mode for broadcast, the state selected by manualcontrol will not change.Switching on permanent manual control mode for broadcastThe DALI Gateway has not yet been programmed via the ETS.Manual control mode or temporary manual control mode for broadcast has not been activated.• Press the key for at least 5 s.The status LED is illuminated. " " is shown on the 7-segment display. Permanent manualcontrol mode for broadcast has been activatedSeite 13 von 130