hager TX216 KNX/EIB DALI-Gateway - UTU

hager"DALI Gateway C00Cx2" softwareParametersResponse to bus voltagereturnThe communication object of the forcedcontrolposition function can be initializedafter bus voltage return. The brightnessstatus of the DALI group can be influencedif the forced-control position function isactivated.No forced-control positionactiveStatus as prior to bus voltagefailureForced-control position active,switching offForced-control position active,switching onNo forced-control position will be activatedafter bus voltage return.The status of the forced- control positionwill be set to the status that waspermanently stored at the time of busvoltage failure. After programming theapplication or the parameters with the ETS,the value is internally set to "not active". Incase of an activated function the DALIdevices of the group will be switched on tothe brightness value provided by the“Brightness for forced-control positionactive, ON” parameter.The forced-control position will beactivated. The DALI devices of the groupwill be switched off by forced control.The forced-control position will beactivated. The DALI devices of the groupwill be switched on to the brightness valueprovided by the “Brightness for forcedcontrolposition active, ON” parameter.• After programming the application or theparameters with the ETS, the forcedcontrolposition will always be deleted.• This parameter becomes visible only ifthe forced-control position function hasbeen enabled.Seite 118 von 130