hager TX216 KNX/EIB DALI-Gateway - UTU

hager"DALI Gateway C00Cx2" softwareParametersResponse at thebeginning of the disablefunctionSwitch-offBlinkingBrightness valueNo changeMemory value (brightnessprior to the last shutoff)The behaviour of the DALI group at thebeginning of the disable function can beparameterized.At the beginning of the disable the groupwill be switched off and locked.During the disable the DALI devices willblink on and off while the bus mode of thegroup is locked. Generally, the blinkingtime for all groups is parameterized on the"General" parameter card. During blinking,the logic switching state is "ON - 1". Thebrightness reported back is the switch-onbrightness. A Soft-ON/OFF function will beignored during the blinking.At the beginning of the disable, the groupwill be adjusted to the brightness valuespecified in the drop-down menu next tothe parameter. The adjustable value isrestricted by the parameterized minimumand maximum brightness.At the beginning of the disable, the DALIdevices of a group will not react and keepthe current brightness value or remainswitched off. The bus mode of the groupwill be locked.At the beginning of the disable, thebrightness value will be set to the valuethat was active and internally stored prior tothe switch-off (via the “Switching” object).This memory value is permanently storedso that the value is pre-defined to themaximum brightness after the return of busor mains voltage or after programming withthe ETS. The bus mode of the group will belocked afterwards.• An output disabled via the bus can stillbe manually controlled at the Gateway!• This parameter becomes visible only ifthe disable function is enabled.Seite 115 von 130