hager TX216 KNX/EIB DALI-Gateway - UTU

hager"DALI Gateway C00Cx2" softwareFunctional description• Set the "Response to bus voltage return" parameter in the "Groups - [x] group name" parameternode to the required behaviour.After bus or mains voltage return, the parameterized state will be adopted in the "Forced-controlposition" communication object. In case of an active forced-control position, the group will beaddressed and locked by forced control immediately after the return of bus/ mains voltage to thecorresponding state until the forced-position condition is cancelled via the bus. In this case the"Response to bus voltage return" parameter in the "Groups - [x] group name" parameter node will notbe evaluated for the affected group.When set to “Status as prior to bus voltage failure” the status of the forced-control position that waslast set and stored internally prior to bus or mains voltage failure will be resumed after the return ofbus or mains voltage. An ETS programming operation will delete the stored state (reaction same as“No forced-control position active”).If the tracked “No forced-control position” state is active, the “Response to bus voltage return”parameter, which is independent of forced control, will be executed after the bus voltage returns. Incase of an activated forced-control position the DALI devices of the group will be switched on to thebrightness value provided by the “Brightness for forced-control position active, ON” parameter.• After programming the application or the parameters with the ETS, the forced control positionfunction will always be deactivated (object value "0").Seite 57 von 130