hager TX216 KNX/EIB DALI-Gateway - UTU

More documents

Recommendations

Info

hager"DALI Gateway C00Cx2" softwareFunctional descriptionSetting the minimum brightnessThe minimum brightness can be set separately for each DALI group.• Set the “Minimum brightness” parameter in the “Groups- [x] group name" parameter node (x = groupnumber 1...32) to the required brightness value.The adjusted brightness will not be under-run in any of the activated operating states.• The adjustable value cannot exceed the parameterized maximum brightness (minimum brightness
hager"DALI Gateway C00Cx2" softwareFunctional descriptionSetting the switch-on brightnessThe switch-on brightness can be set separately for each DALI group.• Set the “Switch-on brightness” parameter in the “Groups - [x] group name" parameter node (x =group number 1...32) to “Brightness value”. Select the required brightness value in the selection field.On reception of an ON telegram the selected brightness will be set to the devices of the DALI groupvia the “Switching” communication object. In addition, the polarity of the parameterized switch-onbrightness will be set to “Activated” on reception of a central telegram.• Set the “Switch-on brightness” parameter in the “Groups - [x] group name" parameter node (x =group number 1...32) to “Memory value (brightness prior to last shutoff)”.When switching on, the brightness value equals the one that was active and internally stored prior tothe shutoff (via the “Switching” or “Switching central function”). This value is permanently stored sothat the value is pre-defined to the maximum after bus or mains voltage return or after programmingwith the ETS.• Setting “Brightness value”: The adjustable value to be selected cannot be smaller than theparameterized minimum brightness and cannot be larger than the configured maximum brightness.• A memory value is internally stored by a switch-off telegram even if the bus controlled switch-off isoverridden, for example, by a disable or forced-control position function or by manual control. In thiscase, the internally tracked brightness value will be stored as the memory value.• If the no Soft-ON function is activated, the brightness value will be activated when switching on.When a Soft-ON function is activated, the switch-on brightness will be adjusted according to thedimming speed for the Soft-ON function.Seite 49 von 130
Page 3 and 4: hagerProduct definition1 Product de
Page 5: hagerFitting, electrical connection
Page 8 and 9: hagerFitting, electrical connection
Page 18 and 19: hagerTechnical data3 Technical data
Page 20 and 21: hagerSoftware specifications4 Softw
Page 22 and 23: hager"DALI Gateway C00Cx2" software
Page 98 and 99:
hager"DALI Gateway C00Cx2" software
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Page 130:
show all

hager TX216 KNX/EIB DALI-Gateway - UTU

Create successful ePaper yourself

Delete template?

Save as template?