C•CURE 800/8000 Monitoring Station Guide - Tyco Security Products

Checking the Status of DoorsInactive only — Displays only door alarms that are inactive.Supervision error only — Displays only door alarms that are in supervisionerror.Alarm StateClick on one of these radio buttons to show alarms according to their type:All — Displays all alarms in the list regardless of their type (Lock tamper,Lock unsecured, Door open, or DSM tamper).Lock tamper only — Displays only lock tamper alarms.Lock unsecured only — Displays only lock unsecured alarms.Door open alarm only — Displays only door open alarms.DSM tamper only — Displays only door switch monitor alarms.Doors Assigned to Intrusion ZonesThe normal default state of a door that is independent of an intrusion zone islocked. However, when a door is assigned to an intrusion zone, the door canhave a default state of unlocked when the intrusion zone mode is disarmed;or one door in the intrusion zone can have a default state of unlocked whileanother door has a default state of locked. If, on the other hand, the intrusionzone is in Armed mode, the default state of the door is Locked.If an intrusion zone changes the state of the door — the door is either lockedor unlocked because of the intrusion zone mode and the door state does notmatch the highest priority cause, then the system generates a new cause in theDoor State list. This situation may happen when a manual action or eventaction has been triggered on the door.If you remove the door from the intrusion zone, or the intrusion zone goes offline,then the door state returns to a state based on the normal non-intrusionzone criteria (manual actions/event actions). If you add a door to an intrusionzone or put it on-line, the door functions as described in the previousparagraph.C•CURE 800/8000 Monitoring Station User Guide 3–15