C•CURE 800/8000 Monitoring Station Guide - Tyco Security Products

Review Event Dialog BoxTable 4-2: Review Event DialogBoxInstructionsLogged MessagesActions Reset byAcknowledged byEvent Status boxLast CauseBecame Active onNumber of CausesMisc InfoEvent StateIncident IDPriority BoxDescriptionDisplays any instructions associated with the event.Displays any messages logged for this event since it became active.Click the Log new message button to add a new message.Displays the user, if any, who reset the actions associated with this event.Displays the user who acknowledged the event.Displays information about the event.Displays the date and time the cause was last active.Displays the number of causes affecting this event.Indicates whether this event will clear when you acknowledge it, regardless of input state, or whetherthis event is annunciated. Events that are not annunciated do not appear at the Monitoring Station or inthe Journal.Indicates the state of the event, whether it is Active or inactive, Armed or Disarmed, etc.The current Incident ID if the event is currently active or the Incident ID of the last incident if the eventis currently inactive.This field is displayed if Incident ID is enabled. Incident ID is disabled by default. To enable Incident ID,select “Driver” in the Settings in the CCURE.INI Section and “UseEventIncidentId” in Entry in the Diagutility and set Entry Value to 1. For more information see the Diag System help.You can copy the Incident ID to the clipboard to paste the Incident ID into the Incident ID field on theIncident Tab in the Journal Replay dialog box in the Administration application. To copy the IncidentID, select the Incident ID, right-click the mouse, and select Copy from the popup menu.Displays the priority of the event.ButtonsAcknowledgeReset ActionsClick this button to acknowledge an event.When you click this button, your user name appears in the Acknowledged by box.If the Allow acknowledgement while inputs are active field is not set, you cannot acknowledge theevent until its causes have reset. If the event requires you to enter a message into the log and nomessage has been entered, the Acknowledge button opens the Log Message dialog box.Click this button to reset actions initiated when this event became active.Actions that were configured as Resettable are reset.4–12 C•CURE 800/8000 Monitoring Station User Guide