C•CURE 800/8000 Monitoring Station Guide - Tyco Security Products

Performing Manual Actions on Security ObjectsPerforming Manual Actions on Security ObjectsThe following dialog boxes, which you access by clicking the appropriatebuttons in the Manual Actions boxes on the respective Status and ObjectSelect dialog boxes, let you perform manual actions on inputs, outputs, doors,readers, elevator buttons, events, dialup iSTAR controllers and apCs, andCCTV actions:• Arm Input and Disarm Input dialog boxes to arm and/or disarm inputs.• Activate Output and Deactivate Output dialog boxes to activate and/ordeactivate outputs.• Lock Door and Unlock Door dialog boxes to lock and/or unlock doors.• Require PIN Entry and Disable PIN Entry dialog boxes to set readermode to require and/or disable PIN entry.• Allow Keypad Commands and Disallow Keypad Commands dialogboxes to enable and disable the entry of keypad commands.• Control Access Button and Uncontrol Access Button dialog boxes tocontrol and/or allow uncontrolled access to elevator buttons.• Latch, Unlatch, Arm Event, Disarm Event, Activate Event, andDeactivate Event dialog boxes to latch, unlatch, arm, disarm, activateand/or deactivate events. You cannot configure a start time for latch/unlatch events. The latch/unlatch event time starts immediately whenyou click OK and close the dialog box. (You can also manually activateevents to print out roll call reports.)• iSTAR dialog box to connect the host to dialup iSTARs.• Connect apC Unit dialog box to connect the host to dialup apCs.• Activate and Deactivate dialog boxes to activate and/or deactivate CCTVactions.Your monitoring privilege controls which manual actions you can perform onspecific security objects, as well as the priority level you can assign to anaction.3–56 C•CURE 800/8000 Monitoring Station User Guide