6 modules - PI-VR GmbH

9 MATERIALS REFERENCE• Repeat Mode: Sets the repeat mode of the texture. There are four modes,which can be set:· Repeat: Repeats the texture in all directions. Repeat· Mirrored Repeat: Repeats and mirrors the texture on the x- and y-axiswith every repetition.· Decal: The texture will not be repeated.· Clamp: Repeats only the last pixel of the texture will be repeated.• Link Repeat Modes: Uses the same repeat mode for v-coordinates as forthe u-coordinates.• Anisotropy: Sets the texture filter quality for the image texture. 1 is lowestquality. 16 is highest quality.• Bump Intensity: Sets the bump intensity interpretation of the bump imagetexture.For further information on the Subsurface Scattering, Displacement, Raytracing, Incandescence,Common and Transparency settings please refer to the ”General TruelightMaterial Settings” section at the beginning of the chapter.300