RoadRunner Owner's Manual - Data I/O Corporation

Troubleshooting • Error Messages •• No Change in LampsError MessagesLampColorError MessageResolutionNo Change in LampsNo changein lampsCard not present.More than one socketpulled over-current.One or more sockets havepulled over current.Insert (or re-insert) a job card into the PCMCIA card slot.• Ensure that the Job options are correct and agree with the type ofdevice.Sockets will be disabled if programmer hardware is degraded• Ensure that the Job options are correct and agree with the type ofdevice.Sockets will be disabled if programmer hardware is degraded.6Adptr.LifeYellowlamp is onVCC for socket 1 haspulled over current.VCC for socket 2 haspulled over current.VCC for socket 3 haspulled over current.VCC for socket 4 haspulled over current.VPP for socket 1 has pulledover current.VPP for socket 2 has pulledover current.VPP for socket 3 has pulledover current.VPP for socket 4 has pulledover current.Waiting for belt to clear...• Ensure that the Job options are correct and agree with the type ofdevice.Sockets will be disabled if programmer hardware is degraded.See above. ↑See above. ↑See above. ↑See above. ↑See above. ↑See above. ↑See above. ↑Wait.Yellow Lamp is OnA bad Update Card wasdetected. Cannot proceedUpdate operation.• Make sure you are not using a Job card.• Try using another PCMCIA card.Adapter life has beenexceeded.Replace the Socket Adapter or expect a decline in throughput.This message displays when socket manufacturers recommendednumber of actuations is exceeded. The Adapter Life number may beviewed (but not changed) on the RoadRunner menu by selectingSocket > Adapter Statistics > Adptr. Life.6—4 Data I/O • ProLINE-RoadRunner Owner’s Manual • 096-0240 [updated Mar2010]