RoadRunner Owner's Manual - Data I/O Corporation

Operation • Operator Functions •• Setting Up RoadRunner for a Programming JobOperator FunctionsPeel BarTape threadingDiagram3Figure 3-15—Loading a Device Tape [Standard Siemens Model Shown]2. Switch the power switch on [I] and allow the system to start up.3. Remove the Robotics Cover.4. Insert the tape into the Tape-In Module to engage with the sprocket.5. Press Menu until the top level menu is displayed.6. Scroll to and select Advance Pocket.CAUTION: Device tape can jam if devices fall into tapepath. Do not advance tape pockets with devices in thempast the pick point. Remove the devices as necessary with avacuum tweezer.For sticking tape to theTake-Up Reel seeFigure 3-16 on page 3-16.7. Press the Up Arrow button to advance the tape.8. When the tape has advanced past the peel bar, separate the cover tapefrom the device tape.9. Thread the cover tape through the tape path as indicated in the tapethreading diagram on the RoadRunner. Attach it to the Cover Tape Reel.A small piece of adhesive tape may be required to stick the cover tape tothe Take-Up Reel.Data I/O • ProLINE-RoadRunner Owner’s Manual • 096-0240 [updated Mar2010] 3—15