RoadRunner Owner's Manual - Data I/O Corporation

Installation • Making the Necessary Connections •• Connecting the Communications CablePansonic MSF, MCF, MPA CommunicationsCommunications are automatically connected when the unit is properlymounted to an SMT machine feeder cart.Pansonic CM401, CM402, DT401 CommunicationsCommunication cable connection is performed when mounting RoadRunneronto a Panasonic Feeder Bank Adapter. See “To connect the CommunicationCable into the Host Feeder:” on page 2-15.2Siemens 80F4, 80F5 Communications (Std and XLF)Orient the cable connector with the red dot on top and plug the communicationcable into the RoadRunner socket on the far end of the electronics housing—facingthe feeder table. Plug the other end into the socket on the SMTfeeder table that corresponds with the track the RoadRunner is mounted in.NOTE: RoadRunner firmware version 02.01.00.B or later isrequired for Siemens communications.To unplug the cable, pull back on the connector collar.Siemens SIPLACE X Series CommunicationsOrient the cable connector and plug the communication cable into theRoadRunner socket on the far end of the electronics housing—facing thefeeder table. There may be a red dot on top for orientation. Plug the otherend into the socket on the SMT Adapter below the conveyor.To unplug the cable, pull back on the connector collar.Universal GSM1, GSM2, GENESIS CommunicationsCommunications are automatically connected when the unit is properlymounted to an SMT machine.Data I/O • ProLINE-RoadRunner Owner’s Manual • 096-0240 [updated Mar2010] 2—29