RoadRunner Owner's Manual - Data I/O Corporation

Operation • Operator Functions •• Programming DevicesOperator FunctionsWhen a device is picked by the SMT machine, the belt moves forward, presentinganother device to the SMT pick head. When a sufficient number ofdevices have been picked, the RoadRunner places another group of programmeddevices on the belt.A red LED will light at each programming socket that fails to successfullyprogram a device. Failed devices are placed into the Reject Bin rather thanon the belt.Stopping or Pausing a JobTo pause the RoadRunner after the current operation has finished, press thePause button on the Keypad.To temporarily stop a job, or in case of emergency, press theEmergency-Stop button. The motor-controlled parts will stop and can nowbe moved by hand.3NOTE: Restarting after the Emergency-Stop button has beenpressed requires re-aligning the device tape. See “Restarting aStopped Job” on page 3-19.NOTE: The job statistics will continue when restarted after stoppingor pausing the job (but not after ending or cancelling a job).!If the main power switch is ON, power is appliedto the electronic systems of the RoadRunner,regardless of the position of the Emergency-Stopbutton or safety shield. Always turn the main power switchOFF before working inside the machine.Restarting a Paused JobTo restart the RoadRunner after a job has been paused, press the Start button.The paused job will resume.Restarting a Stopped JobTo restart the RoadRunner after the Emergency-Stop button has beenpressed, perform the following:1. Twist the Emergency Stop-button clockwise until it springs back to itsnormal operating position.2. Press Menu until the top level menu is displayed.Data I/O • ProLINE-RoadRunner Owner’s Manual • 096-0240 [updated Mar2010] 3—19