RoadRunner Owner's Manual - Data I/O Corporation

Troubleshooting • Problems, but no Error Message •• –Symptom Possible Cause Corrective ActionProgramming Errors; See SocketFailureSocket failure: sockets fail to programdevices successfully (red lighton the Socket Adapter illuminates).Dirty or worn Socket Adapter.Waveform Board or BackplaneBoard malfunction.Incorrect programming parameters.Socket Actuator fails to open socketsproperly due to low air pressure.Socket Actuator position sensor isloose or malfunctioning.• See “Device continuity error” inthe “Error Messages” chart in theBlue Lamp section.• Perform the DAB test. See “Diagnosingwith the Adapter Board”on page 5-5.• Review the Job Statistics inTaskLink to identify problem. Forexample: if the wrong devices areused for the selected job,TaskLink will show an ElectronicID Error.• Check the air regulator.• Inspect sensor. Tighten or replace.Figure 6-1—Socket ActuatorSensor [Universal modelshown]Malfunctioning Waveform Board,Backplane Board, or CPU Board.• Replace the Programmer Module.See “Removing the ProgrammerModule” in the Service Chapter.6Incompatible device data.Faulty devices.• Recreate the job in TaskLink• Use new reel of device tape.Sockets disabled or continuity errors(excessive).Dirty or worn Socket Adapter.• Remove and clean the SocketAdapter in an ultrasonic cleaningtank.Replace the Socket Adapter. See“Changing the Socket Adapter”on page 3-5.Data I/O • ProLINE-RoadRunner Owner’s Manual • 096-0240 [updated Mar2010] 6—21