RoadRunner Owner's Manual - Data I/O Corporation

Troubleshooting • Error Messages •• Blue Lamp is On6LampColor. . .bluelamp is on. . .Error MessageReject bin full.Reject Bin not detected.SECTPROT.TXT file notfound for job.Size of Image.bin fileincorrect.SysFlash.bin is too big to fitin the on-board FLASH.SysFlash.bin is too big.Call Data I/O service.SysFlash.bin programmedin FLASH has failed checksumverification.SysFlash.bin was not readcorrectly. This file may becorrupted.System and device algorithmare not version compatible.The Adapter board is notinstalled.The checksum of theloaded Boot.bin is bad.Update is not done.The checksum of theloaded SysFlash.Bin is bad.Update is not done.Unable to advance tape.ResolutionCAUSE A: REJECT BIN IS FULL• Empty device reject bin.CAUSE B: THE SENSOR IS DEFECTIVE OR NEEDS ADJUST-MENT• Verify that the sensor is working; adjust or replace.Install the reject bin. Ensure that it is correctly in place.Reload job onto card.Ensure the correct data file is being specified in TaskLink.Programmer Module requires repair or replacement.Contact Data I/O Customer Service.Programmer Module requires repair or replacement.Contact Data I/O Customer Service.Programmer Module requires repair or replacement.Contact Data I/O Customer Service.Contact Data I/O Customer Service. A new SysFlash.bin file may berequired.• Reload the Job onto the card.• Check that your Job card algorithm files are compatible with thecurrent system version.Install the Adapter board.Repeat update operation or contact Data I/O Customer Service. A newBoot.bin file may be required.Contact Data I/O Customer Service. A new SysFlash.bin file may berequired.• Make sure the Emergency Stop is not depressed.• Check the tape path for obstruction.• Verify that the Tape-In Sensor is working properly; check connectionat both ends of the cable.6—12 Data I/O • ProLINE-RoadRunner Owner’s Manual • 096-0240 [updated Mar2010]