RoadRunner Owner's Manual - Data I/O Corporation

Operation • Supervisor Functions •• Setting Operational ParametersSupervisorFunctionsCAUTION: Do not move the PNP head while the probeis in the DOWN position. The probe might get damaged.DO NOT SELECT THESE COMMANDS WHILE THEPROBE IS DOWN: Home, Purge, Probe #X speed, orany of the Teach operations—Tape, Skt1, Reject, Belt.While performing any Teach procedure, the PNP head may bemoved incrementally with the Up Arrow or Down Arrow with theprobe in the down position. Use caution.3Setting the “Skt 1” ParameterTo set the socket #1 position for the PNP head:1. On the Keypad, press the Menu button until the top level menu is displayed.2. Scroll to and select Operation.3. Scroll to and select Teach.4. Scroll to and select Skt1. The PNP head should move so probe #1 ispositioned over socket #1.5. Use the Up Arrow or Down Arrow buttons to move the PNP head untilprobe #1 is perfectly centered over socket #1. Pushing probe #1 downby hand and holding it while making this adjustment aids in judgingwhen the probe is centered.6. Press the Menu button to record your setting and move up to the nexthigher menu.CAUTION: Do not move the PNP head while the probeis in the DOWN position. The probe might get damaged.DO NOT SELECT THESE COMMANDS WHILE THEPROBE IS DOWN: Home, Purge, Probe #X speed, orany of the Teach operations—Tape, Skt1, Reject, Belt.While performing any Teach procedure, the PNP head may bemoved incrementally with the Up Arrow or Down Arrow with theprobe in the down position. Use caution.Setting the “Reject” ParameterTo set the Reject Bin position for the PNP head:1. On the Keypad, press the Menu button until the top level menu is displayed.2. Scroll to and select Operation.3. Scroll to and select Teach.3—28 Data I/O • ProLINE-RoadRunner Owner’s Manual • 096-0240 [updated Mar2010]