RoadRunner Owner's Manual - Data I/O Corporation

Operation • Supervisor Functions •• Network SettingsSupervisorFunctions6. When the update has finished, RoadRunner will beep and the blue statuslamp will come on. The following message is displayed on the KeypadDisplay:--Update complete--Insert job card andcycle Power to reboot.7. Insert a job card. Switch the power OFF and then ON again to start theRoadRunner with the updated firmware.3NOTE: Algorithm updates are not performed using the UpdateSoftware menu item. Device algorithms do not reside within theRoadRunner itself. They are provided by TaskLink with the programmingjob on the PCMCIA memory card.Algorithms are updated on TaskLink. For more informationregarding algorithm updates contact your Data I/O sales representative.Network SettingsNetwork commands are covered in Chapter 2. See “Configuring for NetworkCommunication” on page 2-31.ConfigurationThe RoadRunner configuration command is under the System > Configmenu. Here you will find the model designation of your RoadRunner, suchas Model: Siemens-XLF, for example, for RoadRunner eXtra-Large-Format for Siemens SMT machines.The Feeder Comm command allows setting Siemens RoadRunnersshipped after September 2007 to FFI so it communicates withSIPLACE X-Series placement machines.Installed Boards and Hardware Configuration Identification(HwConfigId) are listed, which aid in determining if new device supportalgorithms are compatible with your RoadRunner hardware.Miscellaneous items under System > Config are:• several Prog Key commands used for, and described in, our securedigital management software (sold separately)• (a special request option) a Reel Detect command which detectswhen a reel of devices has been removed and signals the SMT line. Thedefault is Disabled.3—34 Data I/O • ProLINE-RoadRunner Owner’s Manual • 096-0240 [updated Mar2010]