RoadRunner Owner's Manual - Data I/O Corporation

Troubleshooting • Error Messages •• Yellow Lamp is OnLampColorError MessageResolutionCleanAlert.CleanCountAdapter maintenance isrequired. The cleaninginterval has been exceeded.Cover open.Device pick failure at inputwith probe 2.Device pick failure at inputwith probe 3.Device pick failure at inputwith probe 4.Clean the Socket Adapter. For cleaning information, see Sockets in theDaily Maintenance schedule.The clean interval is determined by the number set in the Clean Alert.To reset the counter, on the RoadRunner Menu navigate to Socket >Adapter Statistics > Reset Clean Count. Press the Select button.To change the alert number, on the RoadRunner Menu select Socket >Adapter Statistics > Clean Alert. Use the Up or Down Arrow buttonsto raise or lower the number. Set it to 0 to disable the alert feature.Close the cover.No operator intervention is necessary.(A device is on probe 1.) Operation will continue without a device onthis probe.See above. ↑See above. ↑. . . Yellowlamp is on. . .Device pick failure onprobe 1.(Pick failure at the socket.)No operator intervention is necessary.The programmer socket and probe will be disabled.CAUSE A: DEVICE IS TILTED IN THE SOCKET• Remove the device from the socket.If this error occurs often:CAUSE B: SOCKET IS NOT COMPLETELY OPENED• Verify that the Actuator Plate is fully compressing and opening thesockets. Check for interference.• Verify that the system air pressure is within specified limits. Adjustas required; see specifications at the end of Chapter 1.CAUSE C: MISALIGNMENT OF HEAD• Align the Pick and Place Head.CAUSE D: VACUUM SENSORS ARE OUT OF ADJUSTMENT• Adjust the vacuum sensors.6CAUSE E: PROBE TIP NOT SEATED• Remove and replace the rubber probe tip.• Verify that the rubber cup is on the probe.CAUSE F: THE PICK OR TRAVEL DELAY VALUES ARE TOOLOW• Reset the pick delay.• Reset the travel delay.Data I/O • ProLINE-RoadRunner Owner’s Manual • 096-0240 [updated Mar2010] 6—5