RoadRunner Owner's Manual - Data I/O Corporation

Troubleshooting • Error Messages •• Blue Lamp is OnLampColorError MessageResolutionUnexpected device onprobe 4.See above. ↑Blue Lamp is OnBluelamp is onAdapter board not compatiblewith other boards.Adapter board not supportedby software.Contact Data I/O Customer Service.The required software is on the RoadRunner compact disk (CD) that issupplied with new adapters ordered. Install the CD for the newadapter, (or device or algorithm) onto the computer containingTaskLink.NOTE: The CD has the TaskLink Version andRoadRunner System Software version written on theface of it. If the RoadRunner System Software versionis different from the version shown on the RoadRunnerstartup screen, then you must also update theRoadRunner firmware.Algorithm is not compatiblewith system software.All sockets are disabled.All sockets pulled over current.Backplane board not supportedby software.Boot.bin is not read correctly.This file may be corrupted.Then make a new job card by recreating the job in TaskLink.Reload Job onto card.Ensure that the Job options are correct and agree with the type ofdevice.No operator intervention necessary.Contact Data I/O Customer Service.Replace the update card with a new one.Boot.bin is too big. CallData I/O service.Boot.bin programmed inFLASH has failed checksumverification.Cannot close Boot.bin.Cannot close sockets.Cannot close SysFlash.bin.Contact Data I/O Customer Service.Call Data I/O Customer Service.Replace the update card with a new one.• Check for interference or jammed actuator plate.• Verify that the Socket Open Sensor is working properly.Get a new update card.6Data I/O • ProLINE-RoadRunner Owner’s Manual • 096-0240 [updated Mar2010] 6—7