JMA-5300MkIIsm

INDEX > 4.Replacement Procedure > 4.5 Display Unit : LCD Monitor NWZ-173
2) Remove the four screws (M3) and remove the
mesh cover.
3) Remove the cable and eight screws (M3), and
remove the circuit board.
Remove
Remove
4) Remove the fitting screws from the DVI and
DSUB connectors and remove the shield plate.
5) Install the circuit in the reverse order of the
disassembly. There are two types of fitting
screws, so be sure to use them appropriately
(the shorter screw is for the DVI connector).
6) Follow the procedures provided in Section
4.5.2, page 4-60 to install the LCD unit.
[Check points]
1) After completing the replacement procedures, start the system to make sure that images
are displayed properly.
4-66