JMA-5300MkIIsm

INDEX > 4.Replacement Procedure > 4.6 Display Unit : Radar Process Unit NDC-1417
4.6.4 Battery replacement (CR2032)
[Required tools]
• Flat tip screwdrivers for 6 mm screws
• A Phillips screwdriver for M4 screws
The battery disassembly requires a non-conductive
flat tip screwdriver.
[Replacement procedure]
1) Refer to Section 4.6.2, page 4-70 and remove the terminal board.
2) Insert the non-conductive flat tip screwdriver for adjustment between the battery and
the battery holder and lift the battery up.
3) Insert the non-conductive flat tip screwdriver for
adjustment to the location shown in the figure
below and slide the battery sideways to remove
the battery.
4-76