JMA-5300MkIIsm

INDEX > 4.Replacement Procedure > 4.6 Display Unit : Radar Process Unit NDC-1417
3) Remove the four connectors connected to
the power supply circuit and replace the
power supply unit.
Remove
4) Install the new power supply unit
following the disassembly procedure in
the reverse order.
[Check points]
1) Check that the system starts up properly.
2) Emit radar waves and check to make sure the radar image is correctly displayed.
4.6.2 I/F Unit replacement (NQA-2123)
[Required tools]
Phillips screwdriver for 3 mm screws
[Replacement procedure]
1) Remove the four screws at the top of the
process unit cover and the three screws
on each side to remove the process unit
cover. (Use the Phillips screwdriver for 3
mm screws.)
4-70