JMA-5300MkIIsm

INDEX > 4.Replacement Procedure > 4.2 Scanner Unit NKE-1130 (JMA-5332-12)
3) Loosen the two screws (M4) to remove the
encoder together with the metal fixture.
Encoder
Metal fitting
Remove the two
screws.
4) Remove the metal fixture and the gear wheel
attached to the encoder. Put them onto the new
encoder and put the encoder back into the unit.
5) After replacing the encoder, follow the
disassembly procedure in the reverse order.
Remove the nut
Metal fitting
4
Do not forget to tighten the screws and connect
the cables.
Encoder
Remove the three s
[Check points]
1) Turn on the radar power supply. After the countdown is completed, start emission and
check that the radar image appears without error.Open the serviceman menu to perform
bearing adjustment. (Refer to Section 7.1.4 of the instruction manual)
4.2.14 Brake Control Circuit replacement (CCB-655)
[Required tools]
• A Phillips screwdriver for 4 mm screws
• Tools for removing the cover from the scanner
unit(see Section 4.2.1, page 4-2)
4-19