JMA-5300MkIIsm

INDEX > 2.System Configulation > 2.5 DIP-SW / Jumper Selection
2.5.2 GYRO I/F Unit NCT-59A
DIP-SW/jumper selection
2
Fig.2-8: NCT-59A DIPSW
1) TB100
Not used. To be kept at the factory default setting, alteration prohibited.
2) TB105
Gyro input low voltage.
1-2: Normal setting (factory default setting)
2-3: Gyro low voltage (CD56 lights at 22 Vdc or less. However, the gyro I/
F circuit of the JMA-5300MK2 operates on power supplied from the
display unit even when the display unit is turned off. Thus, there is no
particular need to switch (although it will still operate if it is switched).
It is necessary to switch if using the JMA-5300.)
3) TB106, TB107, TB108, TB109
unmounted
4) TB401-403
1-2: Normal setting (factory default setting)
2-19