Devcon Maintenance and Repair Solutions - Sintemar

More documents

Recommendations

Info

Field Application Reports Products: Application Date: Customer: Industry: Location 51 Pump Repair Titanium Putty / Wear Guard Fine Load 7/1/94 MacMillian Bloedell Pulp and Paper Manufacturing Problem: This fly ash pump would receive extreme wear from processing a slurry of burnt hog fuel (wood chips) and water. The wear was so sever that the pump was replaced every 3 months. Equipment replacement cost was estimated to be $35K. Solution: Complete housing was sandblasted to a SSPC-SP5 white metal finish. Flat expandable metal was tack welded in a raised position .065” above the actual substrate. Tack welding expandable metal improved mechanical bonding properties of Wearguard Fine. The housing was then sandblasted a second time to remove weld slag. The casing was thoroughly cleaned with Cleaner Blend 300. Titanium Putty was applied to the flange area rebuilding the missing metal. Wear Guard Fine Load was applied to the volute to a thickness of 1/2”. Wear Guard Fine Load was pressed through the expandable metal, achieving complete contact to the housing. Wear Guard Fine Load was smoothed, contoured and feathered using acetone as a thinning agent following gel point.
Field Application Reports Products: Application Date: Application Customer: Date: Customer: Industry: Industry: Location 52 Floor Coating Floor Patch / Ceramic Repair Putty / Epoxy Coat 7000 9/9/86 Saint Johns Hospital Building Maintenance Problem: The floor area underneath this large cooking kettle would receive tremendous damage from spalling. The spalling was caused from hot water being discarded down the drain. Solution: Complete surface area was pressure washed to remove all loose concrete. Remaining concrete was roughened using a needle gun. Complete area was then vacuum cleaned. Floor Patch was applied to replace all spalled, damaged concrete. Ceramic Repair Putty was applied to form a slope towards the drain area. Following a partial cure of Ceramic Repair Putty, (4 hours), Epoxy Coat 7000 was applied to a thickness of 8 mils using a 1/8” nap paint roller. Epoxy Coat 7000 provided a long lasting, temperature resistant protective coating.
Page 1 and 2:
Field Application Reports Products:
Page 3 and 4: Field Application Reports Power Pla
Page 5 and 6: Field Application Reports Products:
Page 19 and 20: Field Application Reports Problem:
Page 35 and 36: Field Application Reports Location
Page 53: Field Application Reports Products:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Field Application Reports Location
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141:
show all

Devcon Maintenance and Repair Solutions - Sintemar

Create successful ePaper yourself

Delete template?

Save as template?