Soundtrack Pro 3 Effects Reference (en).pdf - Help Library - Apple

Multipressor Parameters
The parameters in the Multipressor window are grouped into three main areas: the
graphical display in the upper section, the set of controls for each frequency band in the
lower section, and the output parameters on the right.
Graphical display section
Frequency band section Output section
Multipressor Graphical Display Section
• Graphical display: Each frequency band is represented graphically. The amount of gain
change from 0 dB is indicated by blue bars. The band number appears in the center of
active bands. You can adjust each frequency band independently in the following ways:
• Drag the horizontal bar up or down to adjust the gain makeup for that band.
• Drag the vertical edges of a band to the left or right to set the crossover frequencies,
which adjusts the band’s frequency range.
• Crossover fields: Set the crossover frequency between adjacent bands.
• Gain Make-up fields: Set the amount of the gain make-up for each band.
Multipressor Frequency Band Section
• Compr(ession) Thrsh(old) fields: Set the compression threshold for the selected band.
Setting the parameter to 0 dB results in no compression of the band.
• Compr(ession) Ratio fields: Set the compression ratio for the selected band. Setting the
parameter to 1:1 results in no compression of the band.
52 Chapter 3 Dynamics Processors