Distributed I/O System ET 200S

4 IQ-SENSE (6ES7138-4GA00-0AB0)
5.3 Control interface (PIQ) and feedback interface (PII)
5.3.3 Enhanced
Feedback interface (PII)
Table 5-5 Enhanced feedback interface
Address Assignment Designation on
"IQ-SENSE Opto" FB
Byte 0 Bit 0: Circuit state sensor on channel 0
Q_CH0
1: Object detected
0: Object not detected
bit 1 to bit 7:
Acquired sensitivity/distance value at channel 0 by Teach
in 1
Byte 1 Bit 0: Circuit state sensor on channel 1
1: Object detected
0: Object not detected
bit 1 to bit 7:
Acquired sensitivity/distance value at channel 1 by Teach
in 1
Byte 2 Bit 0: Circuit state sensor on channel 2
1: Object detected
0: Object not detected
bit 1 to bit 7:
Acquired sensitivity/distance value at channel 2 by Teach
in 1
Byte 3 Bit 0: Circuit state sensor on channel 3
1: Object detected
0: Object not detected
bit 1 to bit 7:
Acquired sensitivity/distance value at channel 3 by Teach
in 1
1 The current sensitivity/distance value is entered:
- After teach-in is completed on the sensor
- After teach-in is completed via the "IQ-SENSE Opto"
TEACH_VAL_OUT
Q_CH1
TEACH_VAL_OUT
Q_CH2
TEACH_VAL_OUT
Q_CH3
TEACH_VAL_OUT
ET 200S
5-10 Manual, 12/2005, A5E00514527-03