Distributed I/O System ET 200S

New Information About the "ET 200S Distributed I/O
System Operating Instructions" 2
Introduction
This information is new and replaces the information in Sections 7.4, 8.1.3, 8.2.3 and
8.1.4.10 in the ET 200S Distributed I/O System Operating Instructions (A5E00515770-03),
release 12/2005.
2.1 Identification Data
7.4 Identification Data
Reading of identification data
Table 2-1 Identification Data
Identification Data Access Default setting Explanation
Identification data 0: Index 1 (Data record 231)
MANUFACTURER_ID Read (2 bytes) 2A hex (= 42 dec) The name of the manufacturer is stored
here. (42 dec = SIEMENS AG)
ORDER_ID Read (20 bytes) Depends on the
module
SERIAL_NUMBER Read (16 bytes) not relevant
HARDWARE_REVISION Read (2 bytes) not relevant
Order number of the module
SOFTWARE_REVISION Read (4 bytes) Firmware version This indicates the firmware version of the
module.
REVISION_COUNTER Read (2 bytes) - Provides information on parameter
modifications on the module.
PROFILE_ID Read (2 bytes) F600 hex Generic Device
PROFILE_SPECIFIC_TYPE Read (2 bytes) 0003 hex
On electronic modules
0005 hex
on interface modules
IM_VERSION Read (2 bytes) 0101 hex Provides information on the ID data version
(0101 hex = version 1.1)
IM_SUPPORTED Read (2 bytes) 000E hex Provides information on existing
identification data (index 2 to 4)
ET 200S
Product Information, 12/2006, A5E00743001-02 2-1