Distributed I/O System ET 200S

Power modules
2.2 Parameters for power modules
Status byte power modules
2.2 2.2
Parameters
Figure 2-1 Assignment of status byte for power modules
Parameters for power modules
The following table lists the power module parameters.
Table 2-2 Parameters for power modules
Power module
PM-E DC24V PM E-
24 ..48 VDC
Diagnostics:
Missing load
voltage
Diagnostics:
Missing load
voltage
PM-E 24 to 48 VDC/
24 to 230 VAC 1
Diagnostics: Missing
load voltage
Value range Default setting Applicability
Disable/enable Disable Power module
--- --- Diagnostics: Fuse Disable/enable Disable Power module
blown
--- --- Voltage type DC/AC DC Power module
1 The PM-E 24 VDC to 48 VDC, 24 VAC to 230 VAC power module (6ES7138-4CB11-0AB0) is not a direct replacement
for the device with the order number 6ES7138-4CB00-0AB0 for AC applications because you have to select either AC or
DC supply voltage. In the case of DC applications, the new module is a direct replacement because the default setting of
the new parameter is "DC". If you want to replace the device 6ES7138-4CB00-0AB0 in AC applications, you have to create
a new hardware configuration and set the value "AC" for the load voltage type parameter.
Here is a more detailed explanation of the parameters.
ET 200S
2-2 Manual, 12/2005, A5E00514527-03